Skip to main content
Revvity logo
Contact us
Revvity Sites Globally

Select your location.

*e-commerce not available for this region.

australia.webp Australia
austria.webp Austria
belgium.webp Belgium
brazil.webp Brazil *
canada.webp Canada
china.webp China *
denmark.webp Denmark
finland.webp Finland
france.webp France
germany.webp Germany
hong-kong.webp Hong Kong (China) *
india.webp India *
ireland.webp Ireland
italy.webp Italy
japan.webp Japan *
luxembourg.webp Luxembourg
mexico.webp Mexico *
netherlands.webp Netherlands
norway.webp Norway
philippines.webp Philippines *
republic of korea.webp Republic of Korea *
singapore.webp Singapore *
spain.webp Spain
sweden.webp Sweden
switzerland.webp Switzerland
thailand.webp Thailand *
uk.webp United Kingdom
usa.webp United States
Breadcrumb
...
  • ホーム
  • Resources
  • Knowledge Base
  • Application Support Knowledge base (ASK)
  • pHSense
  • pHSense data reduction and analysis
pHSense

pHSense data reduction and analysis

Section
pHSense data reduction and analysis
Critical pHSense assay parameters
pHSense Eu Fab Anti-IgG affinities
pHSense basics
pHSense data reduction and analysis
pHSense probe options
pHSense protocol
pHSense reader settings

For receptor internalization experiments

The signals measured at 620 nm are used to plot the sigmoidal agonist dose-response curves, from which half maximal effective concentration (EC50) values are calculated (potency of the agonist response).

A "fold-of-change" (FOC) ratio is calculated by dividing the signal at 620 nm obtained at each agonist concentration by the signal at 620 nm obtained in the absence of agonist (medium-only condition). The FOC is used to evaluate the amplitude (efficacy) of the response.

For more details, please refer to the manuals of the pHSense™ reagents.

For antibody/ADC internalization experiments

Specific signals are calculated by subtracting the negative (irrelevant) control antibody signal at 620 nm from the test antibody signals at 620 nm. The specific signal is used to plot the sigmoidal agonist dose-response curves, from which half maximal effective concentration (EC50) values are calculated (potency of the agonist response).

A "fold-of-change" (FOC) ratio is calculated, by dividing the signal at 620 nm obtained with the test antibody by the signal at 620 nm obtained with the pHSense Fab only control. The FOC is used to compare various antibodies and various assay test conditions.

For more details, please refer to the manuals of the pHSense reagents and to the "Guide ADC binder internalization".

For research use only. Not for use in diagnostic procedures.

The information provided above is solely for informational and research purposes only. Revvity assumes no liability or responsibility for any injuries, losses, or damages resulting from the use or misuse of the provided information, and Revvity assumes no liability for any outcomes resulting from the use or misuse of any recommendations. The information is provided on an "as is" basis without warranties of any kind. Users are responsible for determining the suitability of any recommendations for the user's particular research. Any recommendations provided by Revvity should not be considered a substitute for a user's own professional judgment.

ON THIS PAGE
Revvity Logo

©2026 Revvity - All rights reserved

Revvity is a trademark of Revvity, Inc. All other trademarks are the property of their respective owners.

Scroll Icon